·
Minimum pressure: 1 bar / maximum: 5 bars (beyond, install a
pressure reducer).
·
Make sure that the supply pressures for hot and cold water are
well balanced.
·
Recommended temperature for adjusting the hot water
installation: 60 ° C (maximum: 80 ° C)
·
Minimum cold water temperature: 10 ° C (a lower temperature
would damage your tap). Very hard water is heavily loaded with
lime stone which accelerates the scaling of your taps.
Treating your water with a softener helps protect your facilities and
extend the life of your equipment.
Terms of use
Before handling, make sure that all components are present and
visually check their good surface condition.
When mounting and / or installing, make sure that by respecting
any instructions, you do not experience any difficulty in screwing,
tightening, fitting.
Unpacking
·
During assembly, the connection hoses must not be damaged
(cutter blow when unpacking), or bent, pinched or twisted.
Otherwise, pressure builds up eventually breaking them open,
which can cause water damage. Also make sure that the supply
hoses are never in contact with any drawers in the cabinet
installed under the sink or basin, otherwise a shearing effect may
result which could cause the hose to burst.
·
For the fitting to your installation: tighten the fitting or the nuts
securely using a wrench. Avoid excessive tightening, which could
break the thread or cause micro cracks which could expand over
time and the pressure of the water and cause a leak.
·
When using for the first time, make sure that your product is
working (in particular that the water flows at the right temperature
and with the right flow rate).
Installation
The proper functioning of the tap therefore requires regular
maintenance.
We therefore recommend:
·
never use abrasive or corrosive products. These aggressive
products attack coatings and tarnish your faucet.
·
clean the chrome surface using a mild soap or soapy water and
a soft cloth making sure to rinse well with clean water after
cleaning.
·
regularly clean the cartridge / tap head (at least once a year),
using of a solution of water and white vinegar (let stand overnight).
·
clean the aerator-aerator by soaking it in a water / white
vinegar solution.
·
activate the moving parts (inverter, lever, crosspiece, pull tab)
at least once per week to ensure smooth operation over time
Maintenance / cleaning
