13
Exhaust vent trim (kit)
Contents.
Top and bottom slider rail (9 x 32 + rebate) 2 off at 200mm
Side slider rail (9 x 32 + rebate)
2 off at 57mm
Vent sliders 3.5mm ply
1 off at 105 x 70
Assemble onto vent panel using 25mm pins (P14).
(P14)
To reduce size of cabin. (All models).
IMPORTANT NOTES (SAFETY CRITICAL).
At all times the clearance distances around the heater must be complied with.
The cabin capacity (M
³
) must be within heater specification. The cabin door must always open
outwards.
To reduce length or width of cabin.
Mark out on the panel (s) the portion to be cut off and cut thro using a saw. (P15).
If metal fixing is hit, use a flexback hacksaw blade in a pad saw to cut fixing. If using a circular saw
use a TCT blade and proceed slowly.
Remove framework (2 x 32) from discarded panel, strip off claddings etc. place 32 x 32 frame
against remaining panel and mark off position of cross braces (P16). Cut framework to marked lines
and push back into panel to be flush and pin in place through outer claddings (P17).
Safety Note.
The panels are constructed using metal fastenings and contain fibreglass/rockwool insulation, safety
goggles and dust mask must be worn if using power tools.
Roof .
Cut roof panel as if for side panel, if reducing length of panel use same sequence, measure, mark, cut,
replace framework and pin in place. (P18).
