Sauna & Steam
Oceanic Saunas 01902 450 550 sales
@oceanic-saunas.co.uk www.oceanic-saunas.co.uk
9
Sauna Heater Manual
6.4. Installing the temperature sensor
i. Install the temperature sensor as in the diagram opposite
ii. Open the cover with a screwdriver
iii. Fix the bottom of the temperature sensor on to wall with screw
iv. Replace the cover.
7. Pre installation checklist for Sauna Heater
Confirm the model you have selected is suitable for your sauna room, please refer to the table
below.
i. Ensure the power supply is suitable for the sauna heater
ii. Isolate the power supply before installation.
iii. The installation position must comply with the minimum distance in the table below and in
the diagrams on the following page
iv. The minimum height of your sauna room must be 1900mm, please refer diagrams on
following page
v. Do not install the sauna heater on the floor or in a cabinet
vi. Do not cover the sauna heater back with asbestos cement or similar material
vii. The wire which enters the sauna room must be type 60245 IEC 66 HO7RN-F (BSEN 6141) please
refer to table below
viii. Do not install two or more sauna heaters in one sauna room.
ix. The sauna heater becomes very hot when operating and must be guarded to protect incase of
accidental contact, please see the sizes in the table below and also refer to charts below and
on following page.
x. The upper supporting screws must be fixed tightly, there is a 3mm gap between the screw
head and wall (refer fig A, fig B), additional retaining screws should be inserted into the round
holes to prevent the heater being lifted.
7.1. Minimum Clearances
Model
Sauna Room
Min Distance from Sauna
(mm)
Current (A)
Fuse (A)
Volume (m
3
)
Min
height
Distance to shelf
over 500mm
Ceiling Floor
230V
1N~
400V
3N~
230v
1N~
400V
3N~
Min
Max
CS20
1
4
1900
50
1100 180
9
/
20
/
CS25
2
4
1900
50
1100 180
11
/
20
/
CS30
2
4
1900
50
1100 180
13
/
20
/
