background image

6

7

TECHNICAL SUPPORT

If you require technical support for any Oceanic Systems products you can reach us using any of 

the following:-

 

 Tel:  +44(0)1425 610022

 

 Fax: +44(0)1425 614794

 

 Email: [email protected]

 

 Web:   www.osukl.com

 

 Post:   Oceanic Systems (UK) Ltd

                          Unit 10-11 Milton Business Centre

                           Wick Drive, New Milton, Hampshire BH25 6RH

Oceanic Systems (UK) Ltd

Unit 10-11 Milton Business Centre, Wick Drive,

New Milton, Hampshire, BH25 6RH, United Kingdom

Tel: +44(0)1425 610022        Fax: +44(0)1425 614794

Email: [email protected]           Web: www.osukl.com

Copyright © 2018 Oceanic Systems (UK) Ltd. All rights reserved. Our policy is one of continuous product improvement so product 

specifications  are  subject  to  change  without  notice.  Oceanic  Systems  products  are  designed  to  be  accurate  and  reliable. 

However, they should be used only as aids to vessel monitoring, and not as a replacement for traditional navigation and vessel 

monitoring techniques. NMEA2000® is a registered trademark of the National Marine Electronics Association.

Please note that below are some FAQ/Troubleshoot Questions. If none of these help or apply, 

then please don’t hesitate to contact Technical Support.

Blue LED not flashing

Check NMEA2000® network cable connection and 

network power

Device not switching relays on command

Check Device Instance Switches match the settings 

required by the control device

Green LED indicates relay operated but device 

connected to the relay output not operating

Check wiring of device

8

TROUBLESHOOTING/FAQ

Summary of Contents for 5980









Reviews: