© Copyright 2008, 2011 Undersea Systems International, Inc., dba
Ocean Technology Systems
. All rights reserved. Specifications subject to change without prior notice.
All users must fully understand the contents of these instructions before use of the product.
Ocean Technology Systems
•
3133 W. Harvard Street, Santa Ana, CA 92704 USA
Toll-free: (800) 550-1984 • Tel.: (714) 754-7848 • Fax: (714) 966-1639 • [email protected] • www.otscomm.com
SSB-1001B
SSB-2010
MK-7
INSTRUCTIONS FOR SSB UNITS:
1.
Connect the RCS-15 charger to the unit after removing
and setting aside the transducer (
see arrow
).
2. Connect the charger’s power input cord to the AC power
source (90–260 VAC, 50–60 Hz).
3. Charge the battery for 4-6 hours, check LED on charger
periodically to ensure it is fully charged.
4. Disconnect the power input cord from the AC power source
and the transceiver from the charger.
transducer
INSTRUCTIONS FOR MK-7 UNITS:
1.
Locate latches on each side of the unit and release to
gain access to the lower housing (battery pack area).
2. Attach battery snap adapter (see p.1) onto RCS-16, then
snap the charger onto the battery pack snaps (see arrow).
2. Connect the charger’s power input cord to the AC power
source (90–260 VAC, 50–60 Hz).
3. Charge the battery for 4 to 6 hours, check LED on charger
periodically to ensure it is fully charged.
4. Disconnect the power input cord from the AC power source
and the transceiver from the charger.
Figure 2: Battery snap adapter (RCS-16 only)
p. 2 of 2
