IR User Guide
1. Plug the IR blaster extension cable into the IR-OUT port of the
Transmitter TX.
2. Plug the the IR receiver extension cable into the IR-IN port of the
Receiver RX.
3.
Place the emitter of the IR blaster as close as possible to the IR
receiver of the signal source device.
4.
Direct the IR remote controller of the signal source device towards
the IR receiver (connected to the RX of HDMI extender), to remote
control source media playback.
Troubleshooting
No image/audio output or degraded signal
Press RX RESET button to reset the device.
Use a shorter network cable.
RX LINK LED is flashing consistently
Ensure the network cable connection follows IEEE-568B
wiring standard.
Ensure TX has an HDMI signal input.
Reset TX & RX and reconnect.
RX LINK LED is on but there is no image output
Press RX RESET button to reset the device.
Ensure the HDMI cable is correctly connected.
Ensure you are using a CAT6 network cable.
Ocean Matrix OMX-HDMI-CAT6
Page 7
OMX-HDMI-CAT6
