MNL-1007 REV A
24
Advanced Settings
Advanced settings are accessed by clicking Spectrometer | Advanced/FFT Settings from
the top toolbar. Advanced Settings and FFT Settings menus will display below the
Spectrum window.
Managing Gain Settings
If the default gain settings are not adequate to the light source, the user
can add a new gain setting. The following steps can be taken to
manage the optical gain settings.
Create new optical gain settings
1.
Click on
Add Optical Gain Settings
button to open the wizard.
2.
In the wizard, type the name of the optical gain you would like to
add in the
Setup Name
field.
3.
Click on
Proceed>>
button.
4.
A window will pop up asking you to connect the light source to
the module. Connect the light source and press
OK
.
5.
To save the settings press on the
Proceed>>
button.
6.
A notification message will popup informing the user that the
settings have been saved successfully.
7.
Press the
OK
button. The setting should now be saved on the
host.
8.
The new optical gain setting should now appear in the
Optical
Gain Settings
drop down list.