STEP
5
A.
Insert the small O-ring into the top of the new switch knob as
shown.
B.
Insert the inner knob and the screw, then place the new On/Off
switch on to the Ocean Guardian.
C.
Note that the On/Off switch knob post on the Ocean
Guardian has small indents that line up with the inner switch
knob indent
STEP
6
Line up the On/Off switch with the ON marker on the main housing.
Note that the inner knob is level with the top of the larger knob.
This indicates that you have correctly aligned the indents.
STEP
7
Gently tighten the screw ensuring it is not too tight.
If it is too tight it will be difficult to rotate the switch if this is the case
back off the screw slightly until the switch is easy to rotate but not
too loose.
Make sure the surface of the inner knob is flush with the top of the
out knob, indicating that the indents are correctly located, as
shown in this picture.
STEP
8
Confirm that your Ocean Guardian is turning on and off with a
green flashing light indicating it is working (out of salt water) If
the light is not flashing confirm your unit is fully charged
Ocean Guardian On/Off Replacement Switch
P/ (08) 9300 0043 | E/ [email protected] | A/ Building 7, 1 Winton Road, Joondalup, Western Australia 6027 | ABN/ 87 099 782 091