1. Connect the power adaptor to the DC socket of the radio and plug in the other end to the wall
socket.
2. Extend the Antenna as far as it can go
.
3. The LCD backlight will light up and shows “PLZ SET TIME”. Press /Mode button to turn on
the radio. The radio will start scanning the DAB channels automatically in the first time:
4. The time will sync to the time broadcasted by DAB, as default:
5. Once the scan is finished, it will display the number of radio stations received, and start to
play the first station automatically.
Note: Always make sure the antenna is extended as much as possible to get the maximum
signal strength and the best possible sound quality.
6. To explore the stations that have been found, you need to press either the ‘Down or ‘Up’ key
to see the next or previous station. When you find a radio station that you would like to listen
to, then press the “ Select” button to select the station. If you don’t press the select key, the
radio will switch to the new station automatically after 5 seconds.
Memory
When you start up the radio again, the radio plays the same mode and same station as last
listened.
Switching your radio on the first time
3
DAB
DAB
2
DAB
2
