9
Fig.12
Water hose
Female threaede
end
NOTE: When the continuous drain feature is not being used,
remove the drain hose from the outlet.
Removing the collected water
3. Pump draining
Water can be automatically emptied into a floor
drain or a suitable drainage facility by attaching
the pump drain out with a pump drain hose
( od=1/4 , supplied).
Remove the continuous drain hose and the drain hose
subassembly from the unit. Install the plastic cover to
the continuous drain hose outlet of the unit by using two
screws.(See Fig.11)
Reinsert
the pump drain hose into the pump drain hose
outlet (See Fig.12), then lead the water hose to the floor
drain or a suitable drainage facility.
Press the pump
button
to activate the pump operation.
When the bucket is full, the pump will start to work.
NOTE: The pump may cause a loud noise when it starts to
work for 3~5 minutes.
This is normal.
Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain,making sure that there
are no
blockages
that will stop the water flowing.
Place the end of the hose into the drain and make sure
the end of the hose is level or down to let the water flow
smoothly.
Do not interrupt the flow.
Select the desired humidity setting and fan speed on the
unit for pump draining to start.
Drain hose
subassembly
Continuous drain
hose
Plastic cover
Fig.11
Pump drain
hose
Pump drain
hose outlet
Fig.12
NOTE: The pump operation on light
flashes
when there
is
a problem
. Please turn off the unit and
unplug the cord.
Check the following things:
Cleaning the filter of the pump.
-Remove the bucket from the unit, take down the pump
and clean the filter. (See Fig.13).
Place the end of the hose into the drain and make sure
the end of the hose is level or down to let the water flow
smoothly.
Do not interrupt flow
.
Place the bucket back in the unit and make sure
that it is
placed
correctly.
Select the desired humidity setting and fan speed
on the unit for continuous draining to start.
Filter of the pump
Check that the pump drain hose does not link or block.
Fig.13
Empty the water of the bucket.
Reinstall the pump and the bucket properly. Turn on the
unit. If the error repeats, call for service.
OPERATING THE UNIT
NOTE: Do not use this operation when the outdoor temperature
O
O
is equal to or less than 0 C (32 F). Otherwise water can turn
into ice that
may block the water hose and cause
the unit to fail.
When the pump drain feature is not being used, remove the
pump drain hose from the outlet.
2,Take the pump
drain hose out
1,Press the pump drain
hose outlet down
Press the pump drain hose outlet down and take the pump
drain hose out from it (See Fig.14).
Fig.14
