ACCESSORIES
CEILING PANEL CONVERSION KIT, CVK-8
The CK-8 can be converted to a dual ducted ceiling panel by use of the CVK-8 conver-
sion kit. The kit contains the parts necessary to install a second 8-Inch duct flange and a
condenser discharge baffle onto the CK-8 ceiling panel. This allows for ducting of con-
denser air to and from the drop ceiling plenum. The kit contains an 8-inch duct flange and
a discharge air baffle that can be installed onto the ceiling panel, as shown below, along
with an 8-inch flex-duct. The baffle can be installed in various orientations, to direct the
discharge air away from the condenser return air above the ceiling panel.
Note—Drop ceiling spaces should be vented or large enough to handle the warm
condenser air. Check local codes to assure compliance
.
WHEN INSTALLED—-THE CONDENSER DISCHARGE SHOULD BE DIRECTED
AWAY FROM THE CONDENSER AIR RETURN
CONDENSER
DISCHARGE
CONDENSER
RETURN
DISCHARGE
BAFFLE
8-INCH DUCT
FLANGE
8-INCH
FLEX-DUCT
CVK-8, CEILING PANEL
CONVERSION KIT
14
11
INSTALLATION—RACK MOUNTING KIT, RMK-1
The 19-Inch Rack Kit allows for the Cool Cube to be installed into any EIA-310-D 4-Post
of 2-Post rack enclosure. The kit includes (2) heavy duty rails (4) side mounting brackets
and a rear mounting rail. The rails have a vibration dampening foam layer secured to the
top for noise reduction. The hardware included in the kit will accommodate most installa-
tions, such as Square Hole Racks, 12-24 Threaded Racks, 10-32 Threaded Racks and
round hole racks.
1. Disconnect Power before Servicing
2. Remove handles and casters from the unit.
3. Install rails in rack and secure with side brackets and hardware.
4. Carefully install Cool Cube into Rack onto of rails.
5. Secure the unit to the rails by use of the rear mounting rail .
REAR MOUNTING
RAIL
SIDE
BRACKETS
HEAVY-DUTY
RAILS