Oce VarioPrint 2050-70, Job Manual

Page: 60 / 174

60 Océ VarioPrint 2050-70 Job manual
Stop or correct a copy job
Introduction
A copy job has the following phases (see ‘ Copy jobs in this manual ’ on
page 30 ).
1
The information of the originals is scanned, digitised and converted in an
image.
2
The images are printed.
3
The bins collect the sets.
The table below shows the actions to take when you stop or correct a phase.
Note:
You can interrupt the copy process before it has finished, to start a new
job. The suspended job is continued after the new job has finished (see
‘Interrupt a copy job’ on page 62).
How to correct: when you make the copy job settings
How to stop: during the scanning process
When Then
You notice an incorrect setting for
the copy job Correct the copy job settings.
The scan process of a job or a job part
fails (phase 1) Stop the scanning process.
The printed sets are incorrect and the
job is not yet finished (phase 2 and 3) Stop the printing process.
If you press the Correction key Then
Once The Océ VarioPrint 2050-70 restores
the default settings.
If you press the Correction key Then
Once The Océ VarioPrint 2050-70 cancels
the copy job.