Oce VarioPrint 2045-65 NC, Job Manual

Page: 165 / 213

The scan function 163
Stop or correct a scan job
Introduction
A scan job has the following phases (see ‘ Scan jobs in this manual ’ on
page 136 ):
1
The information of the originals is scanned, digitized and converted into a file.
2
The image file is transferred from the machine memory to the DA.
3
The generated file is transmitted from the DAC to a scan server and saved in a
server directory.
The table below depicts the actions to take if you need to stop or correct a
phase.
Note:
You cannot delete the generated files that are saved on the DAC (phase
3).
Correcting: when you make the scan job settings
Stopping: During the scanning process
If Then
You notice a incorrect setting for the
scan job Correct the scan job setting.
The scanning process of a job or job
part fails (phase 1) Stop the scanning process.
The generated files that are stored in
the machine memory are not correct
(phase 1 and 2) Delete the generated files from the
machine memory.
If you press the correction key Then
Once The Océ VarioPrint 2045-65 NC re-
stores the default settings.
If you press the correction key Then
Once The Océ VarioPrint 2045-65 NC can-
cels the scan job.