Oce VarioPrint 2045-65 NC, Job Manual

Page: 106 / 213

104 Océ VarioPrint 2045-65 NC Job Manual
Types of copy job settings
Introduction
The Océ VarioPrint 2045-65 NC has default settings, defined by Océ or by the
Key Operator.
If you place the originals in the automatic document feeder, some of the default
settings will change according to the scanned information. You can change the
settings for the copy job.
A dog-ear is displayed on the 'Basic' section to indicate that you changed the
default 'Basic' settings.
Settings when you use the automatic document feeder
When you place the originals in the automatic document feeder, the Océ
VarioPrint 2045-65 NC proceeds as follows.
Settings when you use the platen
When you place an original on the platen, the Océ VarioPrint 2045-65 NC
proceeds as follows.
Procedure
Detects the dimensions of the originals and selects the same or the most ac-
ceptable size for the copy.
Calculates the necessary enlargement or reduction.
Selects the portrait information and the long-edge binding for the original
and the copy settings, when you feed the originals long-edge.
Selects the landscape information and the short-edge binding for the original
and the copy settings, when you feed the originals short-edge.
Procedure
Does not change the default binding and information-orientation settings.
The dimensions of the original on the platen cannot be detected.
Does not change the default enlargement or reduction.