Oce TDS300, User Manual

Page: 44 / 132

44 Océ TDS300 User Manual
Make copies
The copying process starts when you press the Start key. Before you press the
Start key, you can change the settings.
▼
Feed the original
1
Insert the original face down and right aligned, along the original guide line on
the scanner feed table so that you can see the line (see figure 9).
[9] Insert the original
The original will be transported about 1 centimeter to a defined position.
2
Specify the number of copies with the ‘+’ or ‘-’ keys.
3
Press the ‘media’ key to select a roll or to select ‘manual feed’.
4
Press the ‘zoom’ key to specify a reduction or an enlargement factor, if needed.
5
Press the ‘exposure’ key to correct for a lighter or darker original, if needed.
6
Press the ‘strip’ key to add or remove a strip, if needed.
7
Press the green Start key to start the copy job. The original is fed into the
scanner. The printer starts.
8
Collect your output.
If you make a copy within the time-out of 90 seconds, the machine will use the
settings of the previous copy job.