Oce DFS10, Operator'S Manual

Page: 44 / 90

38 Customising your Océ DFS10
Descriptions of the Customer Tools
features
Below are descriptions of the Customer Tools features. To change
any of these features, follow the instructions in the next section of
this chapter.
Energy Saver This feature automatically reduces the power consumption of the
DFS10, if the DFS10 has not been used for a specified time
period. The default time period is one hour. You can adjust this
time period from 0 to 12 hours in 15-minute intervals. If you do not
want to use this feature, set the time period to zero.
You can activate and deactivate Energy Saver mode at any time
by pressing the Energy Saver button on the Control Panel of the
DFS10 or by sending a job from the host machine. As you do so,
the green light to the right of the Energy Saver button goes on
and off accordingly.
Spine Width Units Display This feature allows you to specify how you want the DFS10 to
display cover spine width information in the Message Display and
Cover Supply Contents Display areas of its Control Panel. You
can choose either inches or millimetres. The default for this
feature is ”millimetres” for the A4 machine and ”inches” for the 8,5
x 11” machine.
Attention Lamp This feature allows you to enable or disable the Attention Lamp
located at the top of the Control Panel of the DFS10. This lamp
illuminates to alert you to certain conditions that require your
attention. The default for this feature is ”enabled”.
Sound Tone This feature allows you to enable or disable the Sound Tone for
the DFS10. This tone sounds to alert you to certain conditions
that require your attention. The default for this feature is
”enabled”.
Electronic Counter This feature allows you to reset to zero the Electronic Counter
that tracks the number of books bound during a specified period
of time. Typically, you should reset the Electronic Counter
monthly for record-keeping purposes.
Security Code This feature provides access to the Customer Tools features. The
DFS10 is preset from the manufacturer with a five-button
Security Code. To prevent unauthorized personnel from making
changes to the Customer Tools features, you should change this
default Security Code when you begin using the DFS10 and
periodically thereafter.
NOTE: Whenever you change the Security Code, be certain to
record the new code somewhere. If you forget the new code, you
must place a service call to have the Security Code reset to the
default value.