Oce Arizona 250 GT, User Manual

Page: 153 / 178

153
Empty the Ink Waste Tray
Empty the Ink Waste Tray
Introduction
The waste tray is located below the Maintenance Station. It accumulates ink that has
dripped from the printheads or ink waste that results from a purge when performing
Printhead Maintenance or Swabbing the Printheads. The ink drops onto a sloped
drain plate at the base of the Maintenance Station and drains from there into the
waste tray.
When to do
Check the waste tray periodically and empty, when needed. When you perform
Printhead Maintnance, it is a good practice to visually examine the sloped drain plate
at the bottom of the Maintanance Station. If ink starts to pool on the drain plate it is
time to empty the waste tray (if you can see ink it means the the waste tray is full and
is now backing up into the maintenance station). The capacity of the waste tray is
approximately 1.5 liters.
Required tools
Cloth or paper towel
Empty semi-transparent plastic container
Nitrile Gloves
How to Empty the Waste Tray
1.
Put a cloth or paper towel in place on the floor to catch any drips while the tray is
emptied.
2.
Place a suitable empty container that holds at least 1 liter under the waste tray drain.
[76]
[76] Waste Tray Valve