Oce 3121, Technical & Service Manual

Page: 848 / 908

36 TSM Océ 3121 SDS Description
5 *3* ADJUST (adjustment mode)
Use this mode to fine-adjust or set back-up data needed for copying operations.
■
Use the keypad to enter numbers.
■
Press the key to accept the selected setting.
■
Record all new settings on the service label.
■
When done, turn off and then on the main power switch.
*3* ADJUST 01 Fine-Adjusting and Entering the Multifeeder Paper Width
Basic Setting
Item Description Remarks Settings
MF-A6R
MF-A4R
MF-A4
Use it to fine-adjust or enter the mul-
tifeeder paper width basic setting.
MF-A6R:Indicates the stored A6R
(105mm) value of the multifeeder
paper width sensor.
MF-A4R:Indicates the stored A4R
(210mm) value of the multifeeder
paper width sensor.
MF-A4:Indicates the stored A4
(297mm) value of the multifeeder
paper width sensor.
If you have replaced the image
processor PCB, be sure to
enter the value recorded on the
service label.
For how to enter a new value
after replacement of the
paper width sensor, see serv-
ice handbook p. 2-15.
0~65535