NEP-5000 MANUAL
V2019-08-29
Observator Instruments
Copyright 2019
©
Page 52
9.3.3.
#WD3-C Voltage Subconn
The Connect NEP-5000 Voltage logger:
Figure 9.3.3.A: Voltage Subconn Logger Configuration
1) Description
The NEP-5000 with voltage driver option outputs turbidity is represented as:
-
2.5V to +2.5V, 0
to 2.5V or 0 to 1V. The sensor also allows to control built-in optical wiper using a control wire
or periodic control.
2) Voltage selection
Figure 9.3.3.B: Analog Voltage selection
To select voltage option, please follow steps below:
ü
Select ‘Output Stage’ option
(9.3.3.B1)
ü
Select the ‘Analog voltage’ option
(9.3.3.B2)
ü
Then press, selection
(9.3.3.B3)
and
(9.3.3.B4)
to save settings permanently to the sensor
memory.
For further information regarding voltage output, please refer to section
8.2.4 “Measurement
via Analog Interface”
of this manual.
Note (1)
Note (1): Activate wiper: Short Pin 5 to GND.
Further information, refer to
8.3.2
.
1
3
4
2