procedure, one LED indicator will blink red
3) Upon successful joining there should be LED in-
dication on target device (see manufacturer’s in-
structions)
3. Pair Battery scene controller as an initiator with the
target device:
1) On Battery scene controller press main button 7
times in order to start pairing procedure. During
operation, all LED indicators will blink green 7 times
2) Switch target device to identify mode according to
manufacturer’s instructions
3) On Battery scene controller choose one command
button and press it in order to pair it with target
device
4) Upon successful pairing the end user is able to
control target device from Battery scene control-
ler. On Battery scene controller all LED indicators
will blink red 7 times, which means that the device
switched back to normal mode
INSTALLATION
Battery scene controller can be placed anywhere in the
room or mounted on the wall with supplied mounting
screws (Illustration 3) or adhesive strips (Illustration 4).
When using adhesive strips, make sure that the surface
is clean.
NOTE:
Test the device from desired location before per-
manently mounting it.
Illustration 3
Illustration 4
FACTORY RESET
In order to restore your Battery scene controller to default factory
settings please follow next steps:
1. Press main button 10 times to reset the device to fac-
tory settings
2. After successful operation, all LED indicators will light red
BUTTONS/FUNCTIONS
Mode
Button
operation
Action
LED
indication
NOR-
MAL
MODE
Main button, 1x
short press
Join ZigBee
network
1x blink red
Main button, 5x
short press
Enter scene
setup mode
All LED
indicators
5x green
blink
Main button, 7x
short press
Enter pairing
mode
All LED
indicators
7x green
blink
Main button, 10x
short press
Factory reset
All LED
indicators
red for 3
seconds
Main button
long press (>3
seconds)
Enter key
offset mode
All LED
indicators
3x green
blink
Command
button, 1x short
press
Activate paired
device
1x blink
green
Command
button, 2x short
press
Activate de-
fined scene
1x blink
green
Command but-
ton long press
(>1 second)
Send dimming
command (in
case when
paired device
supports
dimming)
1x blink
green
SCENE
SETUP
MODE
Command
button, 1x short
press
Store scene
1x blink red
PAIRING
MODE
Command
button, 1x short
press
Pairing with
other device
1x blink red
TECHNICAL DATA
Communication Protocol
ZigBee
Range
Up to 15m
Operating Temperature
-5 to 45 °C
Protection Degree
IP20
Power
1 x CR-2450 battery, pre-in-
stalled
Temperature Measurement
-5 to 45 °C; Accuracy: ~1 °C
Dimensions
W x H x D:
97.6 x 91.8 x 14 mm
ATTENTION!
WARNING!
For indoor use only!
WARNING!
Using Battery scene controller in a man-
ner other than outlined in this document is not al-
lowed.
WARNING!
When inserting the battery, make sure
that the polarity is correct!
ATTENTION!
Always keep batteries away from open
flame and high temperatures. Avoid exposure to di-
rect sunlight!
DECLARATIONS OF CONFORMITY
Hereby, OBLO Living LLC declares that Battery scene
controller is in compliance with the essential requirements
and other relevant provisions of following European direc-
tives:
• Council Directive LVD (2014/35/EU)
• Council Directive EMC (2014/30/EU)
• Council Directive RED (2014/53/EU)
• Council Directive ROHS (2002/95/CE)
!
!
!
!
USER MANUAL
ENG