OBID CPR50.10-E, Installation Manual

Page: 24 / 31

OBID
®
classic-pro Installation ID CPR50.10-E/-RE
FEIG ELECTRONIC GmbH Page 24 of 31 M90701-4de-ID-B
E
N
G
L
I
S
H
9.1. Connections
The connection of the ID CPR50.10-xE is carried out via a connection board which will be snapped
into the housing.
Fig. 6: ID CPR50.10-xE connection board with LSA terminal X2
9.1.1. LSA Connection X2 for TCP/IP Interface
The connection of the ID MAX50.10-E with the Ethernet and PoE power supply will be carried out
by a LSA terminal connector X2. For applying the CAT5 cable on to the LSA connector a special
LSA punch down tool must be used.
There are existing two different ways for the connection of a CAT5 cable, EIA/TIA T568A and
EIA/TIA T568B. The typical color coding is shown in the table below.
X2 Signal EIA/TIA T568A EIA/TIA T568B
1 Tx D1+ Green striped Orange Striped
2 Tx D1- Green Orange
3 Rx D2+ Orange Striped Green striped
4 BI D3+ Blue Blue
5 BI D3- Blue Striped Blue Striped
6 Rx D2- Orange Green
7 BI D4+ Brown Striped Brown Striped
8 BI D4-
Brown Brown
Table 1 Connection of the LSA Connector X2
Note:

It is recommended to use a shielded twisted pair STP CAT5 cable.