OBH Nordica Velvet touch, Instructions Of Use

Page: 23 / 28

23
Using the bikiniliner attachment
Make sure that the ladyshaver is switched off. Remove the shaving head by pressing the
two buttons and lift up the shaving head, picture 1. Replace the shaving head by suitable
bikiniliner attachment (3 or 6 mm) depending on accurate shaping, use 3 mm for shorter hair
and 6 mm for longer hair. Push the attachment to the upper part of the housing and then
pressing it into the housing among according to picture 2.
Pull your skin and move the appliance slowly towards the direction of the hair. Use a mild
lotion after shaving.
Foil/trimmer and blade block
There is a natural wear of the foil, trimmer and blade block which may effect the shaving
result. When these parts are worn out the result of the shaving will determine and the parts
should therefore be replaced. The same goes if the parts have been damaged by any reason,
this may also effect the shaving result and may even damage the skin. All three part must
then be replaced. Foil/trimmer and blade block counts as wear parts and is not covered by
the guarantee. These parts can be ordered from OBH Nordica spare parts 08-445 79 00.
Change the foil/trimmer
Open the shaving head by pushing the cleaning button to the right and remove the foil/
trimmer unit, picture 3. Replace the upper part of the shaving head into the same position.
Change blade block
Open the shaving head by pushing the cleaning button to the right and remove the foil/
trimmer unit, picture 3. Hold the blade block at both ends and lift it from it´s position, picture
4. Put the new blade block into position and put the foil/trimmer unit back.
Cleaning and maintenance - after each use
Clean the appliance after use. Make sure that the ladyshaver is shut off. Remove the shaving
head by pressing the two buttons on the sides of the unit and pull the bikiniliner attachment
depending on which you have used, picture 1. Clean the unit with enclosed brush.
Open the shaving head by pushing the cleaning button to the right and remove the foil/
trimmer unit, picture 3. Remove hair from the foil and trimmer with the brush and also clean
the blade block, picture 5. You can also rinse these parts under running water, picture 6.
Remove remaining hair with the brush. Let the parts dry completely before putting them
back.
The housing can be cleaned with a damp cloth and some mild detergent. Regular cleaning
prolong the efficiency and life of the appliance. Foil/trimmer and blade block should be
lubricated with a few drops of sewing machine oil every third month if you use it frequently,
or after each use if you clean it with water.
The ladyshaver must be completely dry before it´s connected to the mains adapter.
Important!
Persons with sensitive skin can easily get irritated skin after shaving. You should •
therefore try the ladyshaver on a small area on your leg or arm before you use the
appliance.
5568_AE_0409.indd 23 2009-04-23 14:26:13