78
You can reset the timer before the time has elapsed by pressing the
SET/AL ON/OFF button to stop the timer and then enter a new time
setting as described above.
Cleaning and maintenance
•
Do not immerse the appliance in water or other liquids. If it
gets wet, wipe it off immediately, as liquids contain minerals
that can make the electronic parts corrode. This applies to the
transmitter as well as the receiver.
•
If the appliance gets dirty, wipe it off with a damp cloth and
dry it with a dry cloth.
•
Do not position the transmitter at places where it could be
exposed to downpour. The transmitter is constructed to
comply with the leakage rate IP33, which means that it is
protected against water falling as rain in an angle up to 60º
from a vertical plane. This means that it will work in Danish
weather, but, in case of periods with heavy downpour, you
should check that the transmitter is not constantly wet. Do not
expose the transmitter to direct sunlight, as this will influence
the measurements. The transmitter is made of a material
that can resist the impact of light under normal temperature
conditions, but a slight miscolouring of the transmitter can
occur over time due to various airborne particles and UV light.
•
Do not expose the appliance to rough treatment, dust, extreme
fluctuations of temperatures or air humidity, which might
affect the optimum functioning of the appliance.
•
Only use new batteries of the correct size. We recommend
Alkaline batteries of a recognized mark. Used batteries shall
always be removed, as they can leak chemicals that damage
the electronic circuit of the thermometer.
•
Do not use rechargeable batteries for the transmitter.
•
If you install the appliance in buildings of concrete and steel,
this might influence the reception, as it may be difficult for the
receiver to catch the signal from the transmitter. In such case,
reposition the receiver and the transmitter to find the optimum
position of both parts.
4830_UL_UVN_100214 002.indd 78
2/14/2014 1:30:58 AM
