OBH Nordica SharpX-treme, Instructions Of Use

Page: 26 / 32

26
• If you only need to maintain the sharpness of your knife you should use the
left wheel with ceramic pins.
• The wheels start rotating when you press the switch and stops when you
release. Never stick your fingers into the rotating wheels.
For best result do as follows:
Using the diamond wheel
• Start the machine by keeping the switch pressed down.
• Place the knife blade close to the handle with a DISTINCT pressure so that
the knife blade is pressed to the wheel. Draw the knife slowly in a smooth
movement towards you during 3-4 seconds.
• It is important to position the knife straight in track during the sharpening
process.
• Avoid to press the knife too hard so that the number of revolutions
decreases considerably.
• Repeat until desired sharpness is maintained.
• Wipe the knife blade after.
• Polish the knife edge in the ceramic wheel.
Maintenance/polishing using the ceramic wheel
• Start the machine by keeping the switch pressed down.
• Place the knife blade close to the handle with a LIGHT pressure.
• Draw the knife slowly in a smooth movement towards you during 3-4
seconds.
• Repeat 3-4 times.
• It is important to position the knife straight in track during the sharpening
process.
• If you press the knife too hard or angle the knife, there is a risk that the
knife edge touches the black plastic edge. This may result in marks on the
knife blade, especially if you use knifes with matt surface.
• Wipe the knife blade after.
General information and warning
• The sharpening-wheel works on both stainless steel and carbon steel.
• The appliance is equipped with a safety system that automatically shuts off
the appliance if it gets over heated. If this happens, wait at least 20 minutes
before using the appliance again.
• Do not use with serrated knives, scissors or ceramic knives.
• Never stick your fingers into the rotating wheels.
• Note that the knife edge gets very sharp, warning for cuts and gashes.
Replacing the diamond wheel
After approximately 2 000 repetitions you might have to replace the diamond
wheel with a new one (can be ordered from OBH Nordica phone 08-629 25
00). Make sure that the appliance is unplugged before you open the appliance.
Open the lid underneath the appliance by unscrewing the two screws. Remove
9967_IDV_UVN_1015.indd 26 2017-02-16 11:22:39