OBH Nordica PREP MIX+, Instruction Manual, Page: 44 / 48

44
Before use, remove all accessories from their packaging and clean them
using hot water and a little washing up liquid, except moto unit (A). Rinse
well and dry thoroughly.
First use
Using hand mixer
• Check that the speed control (A2) is set to “0”.
• Insert the rod of each beater (B) or kneader (D) into the corresponding
holes and lock into place until “click”. The beaters and kneaders have a
specific shape, the kneader or beater with the beater marker (C) should
be positioned to the right, in the biggest hole.
• Connect the appliance:
• Your appliance has five speed levels and a Turbo button. Always begin
mixing or kneading at setting 1 initially, then move to setting 2, 3, 4 or 5.
• After finishing, set the speed control (A2) to “0”.
• Disconnect.
• Then press the ejection button (A1) to remove the beaters or mixers.
Using the base (L) (according to model)
• Place the base (H) on the worktop.
• To raise the arm, unlock by pressing on the button (M)
• Position the bowl (K)
• Press on button (M) to unlock the arm and lower it
• Place the mixer (A), fitted with kneaders (F) or beaters (E), on the hinged
arm until you hear it click into place The beaters and kneaders have a
specific shape, the kneader or beater with the beater marker (G) should
be positioned to the right, in the biggest hole.
• Connect the appliance as instructions above using hand mixer
• After finishing, set the speed control (A2) to “0”.
• Disconnect and press the unlock button (M) to raise the hinged arm.
Then press the mixer unlock button to remove the mixer from its stand.
• Then press the ejection button (A1) to remove the beaters or kneaders.
Using the handblender foot (H ou I) (according to model)
• Check that the speed control (A2) is set to “0”.
• Remove the panel at the back of the appliance (A) and screw the
handblender foot (H or I) by turning clockwise without forcing it, until
you will hear a small click, the rod is correctly positioned (Fig. 12 and 13).
• Connect the appliance:
• Dip the Mixer rod in the preparation before starting to avoid splashing.
• Start using the Eject button
• Stop the appliance before removing from the Blender rod (to avoid
splashes).If you feel resistance when tightening the rod it is not properly
aligned. You should remove it completely and re-screw correctly.
• Select setting “0”, disconnect the appliance and unscrew the
handblender rod (N) by turning anti-clockwise (Fig. 20).