MI SERIES
– Manual (v1.7)
Obelux Oy, Kutomotie 6 B, 00380 Helsinki FINLAND
© Obelux Oy 2017 Technical information in this document is subject to change without notice.
Page: 22(28)
5. Press start button. If programming was successful the green Success LED will turn on.
6. If the RED Error LED turns on the update was not successful. In this case:
•
Disconnect power from the programmer. Re-connect the power to the programmer and press
start button again.
•
Turn the programming cable 180 degrees on the Cyclone programmer
(It is difficult to say what is the correct cable orientation because it depends on which way the
cable is connected on the programming device)
7. Disconnect programming cable from the light and turn on power. Verify that the unit starts up
successfully.
8. Put a new software version sticker on the circuit board. Verify that information presented on this
sticker matches the application image just loaded.
