Installing:
1. Press the left button for 3 seconds and the unit will turn on.
2. Take out the sensors and screw them onto the tyre valves. 1 is front right tyre and so on until
6/8 is rear left tyre sensor.
3. As you screw on the sensors you will see the tyre pressure display for that wheel.
4. Press and hold the middle button for 3 seconds and you will enter the settings screen.
5. Use the left and right button to make a selection then press the set button to move to the next
screen. The screens are in this order:
Display Unit setting - Pressure - PSI or BAR
Display Unit Setting - Temperature - C or F
Low Pressure Alarm Vehicle Tyres
High Pressure Alarm Vehicle Tyres
Low Pressure Alarm Van Tyres
High Pressure Alarm Van Tyres
Press and hold the middle button for 3 seconds to exit this screen and back to the main screen.
Stick the unit on your dash where you can see it.
You should be all set up.
Quick Disconnect for Dropping off Caravan:
Disconnect the caravan tyre pressure sensors:
Press the left and right buttons at the same time to disconnect the caravan, the disconnection
screen will display a horizontal bar,
Connect the caravan again:
Press the left and right buttons again to reconnect the rear tyre pressure.
