3
PREPARATION
Battery Cover
Installing/ Replacing The Batteries
1. Slide the battery cover at the back of the unit.
2. Insert two “AAA” batteries as indicated in the battery compartment and then slide the battery cover back in place.
If the stimulation is too weak, please turn off the monitor and replace all batteries.
1. Plug in the electrode pads to the main unit. Both channels can be used simultaneously or
separately. Stick the pads to the desired parts.
2. Press the ‘ON/OFF’ button, the device will be turned on, the LCD lights all display for
1 second, then the device goes into standby mode and wait for settings.
3. Select the program of therapy. When the ‘ ’ sign shows on the LCD, press the ‘Mode +’
or ‘Mode -’ to select the desired program. Programs can be selected from 1 to 9.
4. Set the time of therapy. Press the ‘Mode’ and when the ‘ ’ sign shows on the LCD, press the
‘Mode+’ or ‘Mode -’ buttons to adjust the desired treatment time. The timer can be adjusted
from 1 minute to 30 minutes, the default time is 15 minutes.
USING THE UNIT
5. To switch between the “PROG” and “TIME”, press the ‘Mode’ button.
6. Set the intensity with CH1+/ CH1- and/ or CH2+/ CH2-, and the treatment will start. Different people need different
intensity, so increase the intensity from 0 to 9 slowly and carefully, stop increasing when reaching the desired intensity.
7. During the treatment, the ‘minute’ sign on LCD ( ) flashes until the treatment ends. The unit will shut off
automatically.
8. If you want to end the treatment any time during the process, press the ‘ON/OFF’ ( ) button.
9. When unplugging the electrode pads, hold the plugs. Pulling the wires may result damage.
10. Please use clear water to rinse the pads gently or use wet cloth (do not use facial tissue) to gently wipe the electrode
pads. Do not use brush or fingernail to clean the pads.
