CX Logix Operation MANUAL
– Updated July 2022
Page 4 of 15
2.
GENERAL OVERVIEW
Congratulations on your recent purchase of your Oasis CX Logix controller.
Please take a moment to read through the entire manual before installing your
new unit. Your CX Logix controller must be installed and operated as specified.
While every effort has been made to ensure that the information contained in this guide is accurate and
complete, no liability can be accepted for any errors or omissions. Crystal Aquatic Systems reserves the
right to change the specifications of the hardware and software described herein at any time without prior
notice.
The pH in your swimming pool will slowly rise due to factors such as alkalinity, the addition of fresh water
and as sanitiser is produced in a salt/mineral water system. A rise in pH reduces the effectiveness of the
sanitiser, so it is important to ensure that the pH remains in the correct range.
The pH of the water can be lowered by the addition of hydrochloric acid
– and if your system has the
optional pH control, this can be done automatically. The CX Logix controller uses an algorithm to
calculate how much how much acid needs to be dosed to correct the pH.
Note:
While the algorithmic pH control is effective, it does not measure pH.
pH testing should be undertaken manually on a weekly basis to ensure the pH is correct.
3.
SPECIFICATIONS
Volts & Amps Input (ac)
220-245 V, 0.1 A
Total Power Consumption)
13 W Motor, 20 W Max.
Frequency
50 Hz
Output as Controlled by Sanitiser
0-1000 ml per hour
Rated Pressure
350 kPa (optimum for injector is 150 kPa)
Squeeze Tube
Tygon® Norprene® (Commercial spec)
Motor Speed
10 RPM
Tubing Size
4m long x 6mm diameter Clear Flexible PVC
Power Cord
Approved piggy-back type
Wall Mounting
Simple Click ON - Clip OFF
Water Connection
CLEAR Acrylic Faucet Tee 50mm pipe
Water Flow Rate (L/min)
80-650 L/min
Ingress Protection Rating
IP35
NOTE
Certain specification may change without notice for reasons of improvement or better performance.
Summary of Contents for CX Logix
Page 1: ......
