Oase ProfiClear Premium TF-XL, Operating Instructions Manual

Page: 71 / 444

- EN -
71
6.3 Operating modes
Description Information
Automatic mode:
• Operating mode for normal operation.
•
The display indicates the water temperature as standard.
• A cleaning cycle is automatically started if the level detection device
signals an excessive deviation in the water level.
•
The level exceeds a certain water level.
• After 20 automatic cleaning cycles, a cleaning cycle with extended
cleaning time is performed.
Time-dependent operation
•
In addition to the automatic cleaning cycle (depending on the water
level in the drum filter), a time-controlled cleaning cycle can be exe-
cuted. (→
In
: Time-dependent cleaning "Interval")
• The duration of the cleaning cycle corresponds to the time set in the
cleaning time "Cleaning" menu. (→
CL
: Cleaning time "Cleaning")
6.4 Manual cleaning
Proceed as follows Information
Press for 3 s
• LED (6) is lit
•
The display indicates
CL
•
To cancel the process: Press the button
again
• The drum motor is stopped for safety reasons if the filter cover is
lifted. The rinsing pump can still be manually started to check the
function of the nozzles.
•
Each active cleaning cycle (automatic, time-dependent or manual)
can be stopped by pressing the button.
6.5 Settings in the menus
T I P
Settings can only be made in the menus when the control system is switched on.
6.5.1
CL
: Cleaning time "Cleaning"
Setting the cleaning time changes the duration of the cleaning cycle. Extend the cleaning time if
the dirt is not completely carried away by the water. This may become necessary if, for instance,
very long drain pipes or drain pipes with many bends were installed or there is a particularly
large amount of sticky dirt (e.g. during spawning).
Please take into consideration that an extended cleaning time leads to increased water con-
sumption. The default setting of 10 s is normally sufficient (corresponds to approx. a
7
/
8
drum
rotation).
Proceed as follows Information
1. Press
several times until
Cl
appears
in the display.
•
To cancel and exit the menu: Either wait for 10 s or press or
.
2. Press
for 5 s until the time is indicat-
ed in the display.
• To cancel and exit the menu: Either wait for 5 s or press or
.
3. Press
several times to change the
value.
• To change the value quickly: Hold down
the button
•
Adjustable range: 10 – 30 s
• Increment: 1 s
•
The number can only be changed upwards. Once the value 30 is
reached, the display returns to 10.
• Saving the set value: Wait for 5 s until the menu is automatically
exited.
•
Cancel without saving and exit the menu: Press or .