Oase ProfiClear Premium Compact-L EGC, Operating Instructions Manual

Page: 32 / 46

- EN -
65
6.3 Operating modes
Description Information
Automatic mode:
• Operating mode for normal operation.
• The display indicates the water temperature as standard.
• A cleaning cycle is automatically started if the level detection device
signals an excessive deviation in the water level.
• The level exceeds a certain water level.
• After 20 automatic cleaning cycles, a cleaning cycle with extended
cleaning time is performed.
Time-dependent operation
• In addition to the automatic cleaning cycle (depending on the water level
in the drum filter), a time-controlled cleaning cycle can be executed. (→
In
:
Time-dependent cleaning "Interval")
• The duration of the cleaning cycle corresponds to the time set in the
cleaning time "Cleaning" menu. (→
CL
: Cleaning time "Cleaning")
6.4 Manual cleaning
How to proceed Information
Press for 3 s
− LED (6) is lit
− The display indicates
CL
− To cancel the process: Press the button again
− The drum motor is stopped for safety reasons if the filter cover is lifted.
The rinsing pump can still be manually started to check the function of
the nozzles.
− Each active cleaning cycle (automatic, time-dependent or manual) can
be stopped by pressing the button.
6.5 Settings in the menus
Settings can only be made in the menus when the control system is switched on.
6.5.1
CL
: Cleaning time "Cleaning"
Setting the cleaning time changes the duration of the cleaning cycle. Extend the cleaning time if the dirt is
not completely carried away by the water, This may become necessary if, for instance, very long drain
pipes or drain pipes with many bends were installed or there is a particularly large amount of sticky dirt
(e.g. during spawning).
Please take into consideration that an extended cleaning time leads to increased water consumption. The
default setting of 10 s is normally sufficient (corresponds to approx. a 7 /
8
drum rotation).
Proceed as follows Information
1.
Press several times until
Cl
appears in
the display.
• To cancel and exit the menu: Either wait for 10 s or press or .
2. Press
for 5 s until the time is indicated in
the display.
• To cancel and exit the menu: Either wait for 5 s or press or .
3. Press
several times to change the
value.
• To change the value quickly: Hold down the
button
• Adjustable range: 10 – 30 s
• Increment: 1 s
• The number can only be changed upwards. Once the value 30 is reached,
the display returns to 10.
• Saving the set value: Wait for 5 s until the menu is automatically exited.
• Cancel without saving and exit the menu: Press or .
Downloaded from www.watergardeningdirect.com