Oase Profi Clear Premium Compact L US, Operating Instructions Manual

Page: 39 / 116

- EN -
Questions, problems, missing parts?
Before returning to your retailer, call us at 1 -866-627- 3435, 8 a.m. - 6 p.m., EST, Monday - Friday, or email
us at customercare@oase- livingwater.com. Or visit our website at www.oase - livingwater.com
39
8.4 Cleaning the rinsing device
How to proceed:

P
1. Remove the cover and start a manual cleaning cycle to check that the rinsing nozzles are functioning
perfect ly. (

(Manual cleaning)
2. Loosen the union nut on a clogged nozzle, remove it together with the nozzle and seal from the rinsing
pipe and clean the parts.
3. Push the union nut onto the nozzle and screw it together with the seal onto the rinsing pipe.
– Align th e nozzle so that the marking is at the top.
– Hand-tighten the union nut.
– Replace the cover.
8.5 Cleaning the screen elements
8.5.1 Removing/fitting a screen element
How to proceed:

Q
Removing
1. Turn the filter drum manually until the screen element is located opposite the drum motor. Undo the
locking mechanism (turn through 180°).
2. Lower the screen element completely into the filter drum.
3. Remove the screen element from the filter drum.
Fitting
4. Lo wer the screen element completely into the filter drum.
5. Turn the screen element and push the two hinges onto the support of the filter drum.
6. Use the cross element to pull the screen element up.
7. Close the locking mechanism (turn through 180°).
8.5.2 Decalcifying the screen elements
The error messages
Er33
,
Er55
or an excessive rise in the frequency of cleaning cycles (counter) indicate
that there are limescale deposits on the screen elements. (→ Reading out the number of cleaning cycles)
Oase recommends that you descale the unit every two to three months as a preventative measure if the
water is very hard.
Recommended descaling agent:
► Soak screen elements in vinegar concentrate (20 … 25 % acid) until the limescale deposits have
dissolved.
► Sprinkle citric acid powder onto moistened screen elements and allow it to react until the limescale
deposits are dissolved.
► Recommended cleaning agent for removing stubborn limescale deposits:
– Pump cleaning agent PumpClean from OASE.
– Vinegar- and chlorine-free household cleaning agent.
How to proceed:
1. Remove the screen element. (→ Removing/fitting a screen element )
2. Remove limescale from the screen element.
– Do not remove the rubber seal of the screen element.
3. Scrub the screen element with a soft brush under running water and rinse well.
4. Refit the screen element.