Oase LunAqua 10 Halogen, Operating Instructions Manual

Page: 8 / 52

- EN -
8
Set-up and start-up
The unit comes without bulbs and transformer. Please refer to „Bulb replacement“ when fitting the bulb. When set up
above the water level, maintain a safety distance of at least 50 cm from combustible material. Ensure a safe seating.
Do not cover the unit. Danger of fire! A swivel bracket (4) can be fitted to the spotlight by means of a screw connection.
Position the unit such that it does not present a hazard for anybody. When fitting in the pond, fasten the unit on a suita-
ble base by means of the swivel bracket. The ground stake (5+6) can be used when installing the unit out of the water.
Connect the power plug of the spotlight to the socket of the transformer bush (2+3). Connect the transformer to the
power supply. Check the spotlight function.
Replacing the bulb (1)
Adhere to the safety instructions! Disconnect the power! Undo the screw-connection of the top section. Ensure that no
moisture can enter the unit. Remove the top section and the glass, clean, if necessary. Take the bulb out of the hous-
ing. Important! Only original bulbs from OASE may be used. Insert new bulb (do not touch, use a cloth or similar).
Check the O-ring and replace, if damaged. Reassemble the unit in the reverse order, connect to the power supply and
perform a function check.
Cleaning
Adhere to the safety instructions! Carry out the work steps as specified under 'Replacing the bulbs'. Only use water
and a soft brush. Ensure that no moisture can enter the unit.
Disposal
Dispose of the unit in accordance with the national legal regulations.
S Malfunctions
Malfunction Cause Remedy
Lamp does not light up Power supply interrupted Check power supply
Bulb defective Replace bulb
Bulb contacts corroded Clean contacts
Light intensity decreases Lamp glass soiled Clean
Water in the spotlight housing Seal defective Check sealing rings and replace, if necessary
Light flickers Contacts corroded Clean lamp pins