Oase AquaAir Eco 250, Commissioning, Page: 15 / 140

EN
15
Connecting the control system
 D
Connect the AquaAir Eco 250 to the OASE Garden Controller or the OASE InScenio FM-Master
Home/Cloud and control the AquaAir Eco 250 using OASE Control.
•
For information on OASE Control visit www.oase.com .

Integrate the AquaAir Eco 250 in the OASE Control network either as the only or as the final
station.
−
The line length in the OASE Control network is limited. If the network cable is looped
through (IN/OUT) on the AquaAir Eco 250 the network cable can reach a length of 197 ft
due to the 98 ft network connection cable.
Connecting and disconnecting the OASE Control plug connection
 E
NOTE
The unit will be destroyed if water penetrates the plug connector.
•
Connect the plug connector or place the protective cap on the plug connector.
–
Ensure that the rubber seal is clean and fits precisely. If the rubber seal is damaged, replace
it.
–
Secure the plug connector or protective cap with the two screws.
Installing the unit
 F
WARNING
Severe injuries or death from operation of the unit in a swimming pond. Faulty electric compo-
nents will apply dangerous electric voltage to the water.
 Never operate the unit in a swimming pond.
Ensure that the connection to the power supply is at least 6.5 ft from the edge of the pond.
Fastening the unit on the side of the pond
 G
•
Shorten two wire cables to the desired length.
•
Form loops at each of the cable ends and fasten these with cable clamps.
•
Anchor the aerator using the two wire cables, the safety hook and the two pegs driven in at
the side of the pond.
–
Adhere to the specified anchoring angles so that the aerator cannot move.
•
Relieve strain from the power cable and protect the power plug from wetness.