4
INSTALLATION
The tables come completely assembled and ready to use. Plug the cord into a functioning outlet that is rated for
the table. (see Grounding below)
Arrange the power cord and control cords so that they will not create a tripping hazard.
Be sure access to the plug is not blocked for disconnecting the table from power.
PREPARE YOUR PROLUXE CONVERTIBLE
This is a one time only procedure for each given portable table.
1. Loosen all knobs below the
adjustable portable supports by
turning the knob counter-clockwise.
2. Slide the adjustable portable table
supports to their widest position.
3. Remove the portable table secure
strap from the strap cleat (if necessary).
4. Plug in the Convertible and lower
to its lowest height.
5. Open your portable table on its
side.
6. Remove the Shiatsu cables or bolts
on one side to enable your table to
lay flat. There are different types of
shiatsu cables. Follow these directions
based on the type you have. Or follow
your table manufacturer’s instructions.
NOTE: Some systems may be slightly
different such as; cable not between
braces, hex nut instead of wing nut.
You may need to use a wrench to
remove the bolt.
WING NUT: Repeat these steps on both sides of the table. Locations shown above.
Remove the wing nut Remove wood brace Remove cable
Replace wood brace
and wing nut
C-CLAMP: Repeat these steps on both C-Clamps.
C-Clamp closed
Open C-Clamp
Remove Shiatsu cable Close C-Clamp
