background image

 WARNINGS

5

CARE & 

CLEANING

UPHOLSTERY

In order to maintain your product’s quality and ensure the life of your upholstery, we 

have tested several preventative steps you can take to protect the upholstery fabric on 

your table and accessories.
Here are a few suggestions in caring for your upholstery fabric:

DO NOT store your table or upholstery fabric-covered accessories in temperatures

below 32°F/0°C or above 95°F/35°C. Extreme hot and cold temperatures will

damage the upholstery fabric. Some potential results are cold-cracking, brittleness

and upholstery fabric stretching. And, always keep your table away from heaters,

electrical appliances and direct sunlight.

We recommend cleaning your upholstery fabric to protect it against oil stains and

dirt which will cause cracking and permanent stains over time.  Clean your uphol-

stered items when needed using a mild solution of 4:1 diluted non-alcohol cleaner

such as Formula 409

®

, Fantastik

®

, Green Windex

®

 or some other non-abrasive

cleaner. For disinfecting purposes you may use Protex, MadaCide, Accell TB,

Virox

®

 (Canada) or a diluted 1/100 bleach solution. Dry the table immediately after

cleaning to remove excess cleaning solution. Using citrus based cleaners or other

strong cleaners, such as alcohol, acetone, higher concentrations of bleach or other

products that contain high concentrations of these substances, can shorten the life

of your fabric, or discolor it.

Note: Damage caused by cleaners will not be covered under the warranty.

Use both ends of the table evenly. Occasionally switch the face rest from one end

of the table to the other to reduce uneven wear.

Protect your table and accessories with sheets and fleeces. We offer both fitted

sheets and thick fleeces that protect your upholstery fabric against oil stains while

offering comfortable softness to your clients. You can also preserve your face rest

and bolsters with covers and fleeces.

Use only a mild solution of 4:1 diluted non-alcohol cleaner such as 409

®

, Fantastik

®

or some other non-abrasive cleaner to wipe down the wooden surfaces. Apply with

a damp (not wet) lint-free cloth. Wipe these areas dry carefully with a lint free cloth.

The wooden cabinetry of the equipment can be polished with any polish approved

for wooden surfaces. Spray, or pour the polish onto a soft cloth and be careful not

to get it onto other surfaces.

It is important to visually inspect your table on a quarterly basis to ensure all

components are working properly and safely. Be sure to tighten all bolts to be sure

they are secure. Over time they may work their way loose, leading to an unsafe

condition.

• 

 

• The face rest and table extender should be removed when not in use.

These items should be stored in a cool, dry place.

BASE 

ACCESSORIES

Summary of Contents for Clinician Adjustable Lift Assist Salon Top









Reviews: