Oakley Hollow Point, Instruction Manual

Page: 10 / 100

8 | Hollow Point
™
inStRUCtion MAnUAl
to ADJUSt tHE CHRonoGRAPH HAnDS
1. If the chronograph hands currently show a measured
time, use button “B” to reset them near the zero position.
Note that the hands must be stopped before using
button “B” to reset them. If necessary, use button “A”
to stop the hands.
2. Unscrew the crown from the case. Pull the crown out
to the second click position (b).
3. Push button “A” and button “B” simultaneously and
keep them pressed for at least 2 seconds.
4. Adjust the chronograph hands by doing the following:
• Press button “A” to adjust the chronograph hand
that counts seconds. (Press and hold the button for
continuous movement.)
• Press button “B” to finish with that hand and move
on to the other hands.
• Press button “A” to adjust the chronograph hand
that counts 1/10 seconds, then the hand that
counts minutes. (Press and hold the button for
continuous movement.)
5. Push the crown back in. Gently turn the crown
clockwise until it screws back into the case. Be
careful not to over tighten the crown, as this will
damage the mechanism.
a b
Chronograph
Second Hand
Chronograph
1/10 Second
Button B
Button A
Seconds
Counter
Chronograph
Minutes
ADjuSTiNG THE CHrONOGrAPH HANDS
When the chronograph is reset with button “B,” the three chronograph hands return to the zero position. If these
hands do not align precisely with the zero position (such as after the battery is replaced), use the following procedure
to adjust them.