Check the neutral position of servos with a servo tester
An exemple of servo mounting on the tray
Servo mounting:
It is imperative to do so only once the tray has been glued in right place
. Two screws per servo. Check
the screw diameter against the tray’s pre-drilled hole,
the plastic is hard and fragile screws may break while screwing in,
which would obviously complicate assembly.
(if needed, drill it again with a 1.2mm bit)
3 types of servo trays available:
4 x KST 08 ‘ , 4 x MKS DS75K ‘ and 2 x KST 08 + 2 x MKS DS75K ‘.
You can replace KST08 by Dymond D47 for tails (light versions).In this case, glue a little piece of 4x4mm (pine wood)
under the D47 leg , to have the right horn’s height position. D47 works in 1S, but it’s better to supply it with a 5 to 6 V
voltage booster.
Ailerons servos and linkage system mounting:
Mount the ailerons servos close to the wing and the tails servos on the front of the tray. Ailerons linkages must be as
short as possible.
Here, sleeves are only dry mounted to check their possible length.
To insert the servo wires in place, disassemble the servo leads from the plugs while being careful with the order of those
leads in the plug. Then use a thin string attached to one or all three leads and pull them through the channel towards the
front of the fuselage. If necessary, gently separate the joined wires from each other by pulling the leads apart to have
