![background image](http://html.mh-extra.com/html/o-s-engine/max-18tz-series/max-18tz-series_owners-instruction-manual_719745003.webp)
4
NOTES
Before starting the engine, always check
the tightness of all the screws and nuts
especially those of joint and movable
parts such as throttle arm. Missing
retightening the loose screws and nuts
often causes the parts breakage that is
capable of harming you.
This engine is intended for model cars.
Do not attempt to use it for any other
purpose.
Mount the engine in your model
securely, following the manufacturers'
recommendations, using appropriate
screws and locknuts.
Fit an effective silencer (muffler).
Frequent close exposure to a noisy
exhaust (especially in the case of the
more powerful highspeed engines) may
eventually impair your hearing and such
noise is also likely to cause annoyance
to others over a wide area.
The wearing of safety glasses is also
strongly recommended.
Take care that the glowplug clip or
battery leads do not come into contact
with rotating parts. Also check that the
linkage to the throttle arm is secure.
For their safety, keep all onlookers
(especially small children) well back (at
least 20 feet or 6 meters) when
preparing your model for running.
5
NOTES
To stop the engine, fully retard the
throttle stick and trim lever on the trans-
mitter, or, in an emergency, cut off the
fuel supply by pinching the fuel delivery
line from the tank.
Warning! Immediately after a glowplug-
ignition engine has been run and is still
warm, conditions sometimes exist
whereby it is just possible for the engine to
abruptly restart if it is rotated over
compression WITHOUT the glowplug
battery being reconnected.
Pull the operating handle straight out
when starting the engine, so that the cord
does not rub against the vehicle body or
engine. This will help prevent the cord
from being damaged by abrasion or
engine heat.
Do not extend the starter cord more than
40cm (16"). Do not abruptly release the
operating handle. Allow the cord to
rewind smoothly while still holding the
handle.
Do not attempt to disassemble the recoil
starter of the 18TZ-TX. If you do so, the
very strong spring inside will be suddenly
ejected. This can be very dangerous.