THE EDEN COLLECTION
For assembly advice or parts go www.compacfurniture.co.nz or call 0800 100 858
STEP 3
– TOP
•
Lay the Top of the unit finished side down on a clean, clear surface.
•
Screw four
H1 Connecting Bolts
into the holes indicated in the drawing below.
•
Using the
Pan head screw
, attach the Safety Strap as shown by screwing it first through the
washer
and then through
the eyelet in the Strap, into the hole in the left-hand side of the Top. Make sure that the Strap is positioned so that the
tail end falls through the hole in the edge of the Top as shown below.
STEP 4
– RAILS AND TOEBOARDS
Your pack will contain:
•
4 x Drawer Rails
•
1 x Toeboard
•
2 x Back Rails
To distinguish the difference between the various boards, please see the parts list on page three if this instruction booklet.
•
Install two
H2 Cams
into each piece as indicated
•
Push the
H15 Dowels
into each of the boards as indicated
The hardware is installed into each board in the same manner.
H2 Large Cams
H15 Dowels
H1 Connecting Bolt
H7 Pan head
Safety Strap
Screw the H7 Pan head screw through
the washer
