NY-GS10
FIRST TIME SETUP CONTD.
Connect power to Transmitter. Connect Transmitter to RCA output on source
device with RCA cable. Examples of a source device include Cable Boxes, Satellite
Receivers, DVD Players, and VCRs.
2
TRANSMITTER
DEVICE
Set the Channel Selection switch on both the Transmitter and the Receiver to the
same channel. Set the Power Switch on both to the ON position.
Note: If signal is not clear or if devices are not connecting change the channel
on both the Transmitter and the Receiver.
3
TRANSMITTER
Power
Channel Selection
Connect IR Emitter to Transmitter and place 5-10 cm in front of source device. Test
remote control by pointing it at the Receiver, an LED should flash on the Receiver.
If there is no response, change the Remote Frequency switch and test again.
4
RECEIVER
