UM10310_1
© NXP B.V. 2008. All rights reserved.
User manual
Rev. 01 — 1 December 2008
38 of 139
NXP Semiconductors
UM10310
P89LPC9321 User manual
[1]
The value shown is for a power-on reset. Other reset sources will set their corresponding bits.
6.1 Reset vector
Following reset, the P89LPC9321 will fetch instructions from either address 0000h or the
Boot address. The Boot address is formed by using the Boot Vector as the high byte of the
address and the low byte of the address = 00h. The Boot address will be used if a UART
Fig 14. Block diagram of reset
RPE (UCFG1.6)
RST pin
WDTE (UCFG1.7)
watchdog timer reset
software reset SRST (AUXR1.3)
power-on detect
UART break detect
EBRR (AUXR1.6)
brownout detect reset
chip reset
002aae129
Table 22.
Reset Sources register (RSTSRC - address DFh) bit allocation
Bit
7
6
5
4
3
2
1
0
Symbol
-
BOIF
BOF
POF
R_BK
R_WD
R_SF
R_EX
Reset
x
0
1
1
0
0
0
0
Table 23.
Reset Sources register (RSTSRC - address DFh) bit description
Bit Symbol Description
0
R_EX
external reset Flag. When this bit is logic 1, it indicates external pin reset. Cleared by software by writing a
logic 0 to the bit or a Power-on reset. If RST is still asserted after the Power-on reset is over, R_EX will be set.
1
R_SF
software reset Flag. Cleared by software by writing a logic 0 to the bit or a Power-on reset
2
R_WD
Watchdog Timer reset flag. Cleared by software by writing a logic 0 to the bit or a Power-on reset.(NOTE:
UCFG1.7 must be = 1)
3
R_BK
break detect reset. If a break detect occurs and EBRR (AUXR1.6) is set to logic 1, a system reset will occur.
This bit is set to indicate that the system reset is caused by a break detect. Cleared by software by writing a
logic 0 to the bit or on a Power-on reset.
4
POF
Power-on Detect Flag. When Power-on Detect is activated, the POF flag is set to indicate an initial power-up
condition. The POF flag will remain set until cleared by software by writing a logic 0 to the bit. (Note: On a
Power-on reset, both BOF and this bit will be set while the other flag bits are cleared.)
5
BOF
BOD Reset Flag. When BOD Reset is activated, this bit is set. It will remain set until cleared by software by
writing a logic 0 to the bit. (Note: On a Power-on reset, both POF and this bit will be set while the other flag
bits are cleared.)
6
BOIF
BOD Interrupt Flag. When BOD Interrupt is activated, this bit is set. It will remain set until cleared by software
by writing a logic 0 to the bit.
7
-
reserved
