NXP Semiconductors MKW01Z128, Reference Manual

Page: 276 / 884

7.5.4 Interrupt Status Flag Register (PORTx_ISFR)
The corresponding bit is read only for pins that do not support interrupt generation.
The pin interrupt configuration is valid in all digital pin muxing modes. The Interrupt
Status Flag for each pin is also visible in the corresponding Pin Control Register, and
each flag can be cleared in either location.
Address: Base a A0h offset
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
ISF
W
w1c
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
PORTx_ISFR field descriptions
Field Description
ISF Interrupt Status Flag
Each bit in the field indicates the detection of the configured interrupt of the same number as the field.
0 Configured interrupt is not detected.
1 Configured interrupt is detected. If the pin is configured to generate a DMA request, then the
corresponding flag will be cleared automatically at the completion of the requested DMA transfer.
Otherwise, the flag remains set until a logic 1 is written to the flag. If the pin is configured for a level
sensitive interrupt and the pin remains asserted, then the flag is set again immediately after it is
cleared.
7.6 Functional description
7.6.1 Pin control
Each port pin has a corresponding Pin Control register, PORT_PCRn, associated with it.
The upper half of the Pin Control register configures the pin's capability to either
interrupt the CPU or request a DMA transfer, on a rising/falling edge or both edges as
well as a logic level occurring on the port pin. It also includes a flag to indicate that an
interrupt has occurred.
The lower half of the Pin Control register configures the following functions for each pin
within the 32-bit port.
• Pullup or pulldown enable on selected pins
• Drive strength and slew rate configuration on selected pins
Chapter 7 Port Control and Interrupts (PORT)
MKW01Z128 MCU Reference Manual, Rev. 3, 04/2016
Freescale Semiconductor, Inc. 145