NXP Semiconductors KE1xF Series, Reference Manual, Page: 830 / 1483

Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
0
COCO
AIEN
0
ADCH
W
Reset
0 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1
ADCx_SC1n field descriptions
Field Description
31–8
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
7
COCO
Conversion Complete Flag
This is a read-only field that is set each time a conversion is completed when one or more of the following
is true:
• The compare function is disabled
• SC2[ACFE]=0 and the hardware average function is disabled
• SC3[AVGE]=0
If the compare result is true, then COCO is set upon completion of a conversion if one or more of the
following is true:
• The compare function is enabled
• SC2[ACFE]=1
COCO is set upon completion of the selected number of conversions (determined by AVGS) if one or
more of the following is true:
• The hardware average function is enabled
• SC3[AVGE]=1
COCO in SC1A is also set at the completion of a calibration sequence.
COCO is cleared when one of the following is true:
• The respective SC1n register is written
• The respective Rn register is read
0 Conversion is not completed.
1 Conversion is completed.
6
AIEN
Interrupt Enable
Enables conversion complete interrupts. When COCO becomes set while the respective AIEN is high, an
interrupt is asserted.
0 Conversion complete interrupt is disabled.
1 Conversion complete interrupt is enabled.
5
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
Table continues on the next page...
Memory map and register definitions
Kinetis KE1xF Sub-Family Reference Manual, Rev. 4, 06/2019
830 NXP Semiconductors