NXP Semiconductors KE1xF Series, Reference Manual, Page: 379 / 1483

FTFE_FOPT field descriptions
Field Description
OPT Nonvolatile Option
These bits are loaded from flash to this register at reset. Refer to the device's Chip Configuration details
for the definition and use of these bits.
17.4.4.5 Flash Common Command Object Registers (FTFE_FCCOBn)
The FCCOB register group provides 12 bytes for command codes and parameters. The
individual bytes within the set append a 0-B hex identifier to the FCCOB register name:
FCCOB0, FCCOB1, ..., FCCOBB.
Address: 4002_0000h base + 4h (1d × i), where i=0d to 11d
Bit 7 6 5 4 3 2 1 0
Read
CCOBn
Write
Reset
0 0 0 0 0 0 0 0
FTFE_FCCOBn field descriptions
Field Description
CCOBn The FCCOB register provides a command code and relevant parameters to the memory controller. The
individual registers that compose the FCCOB data set can be written in any order, but you must provide all
needed values, which vary from command to command. First, set up all required FCCOB fields and then
initiate the command’s execution by writing a 1 to the FSTAT[CCIF] bit. This clears the CCIF bit, which
locks all FCCOB parameter fields and they cannot be changed by the user until the command completes
(CCIF returns to 1). No command buffering or queueing is provided; the next command can be loaded
only after the current command completes.
Some commands return information to the FCCOB registers. Any values returned to FCCOB are available
for reading after the FSTAT[CCIF] flag returns to 1 by the memory controller.
The following table shows a generic FTFE command format. The first FCCOB register, FCCOB0, always
contains the command code. This 8-bit value defines the command to be executed. The command code is
followed by the parameters required for this specific FTFE command, typically an address and/or data
values.
NOTE: The command parameter table is written in terms of FCCOB Number (which is equivalent to the
byte number). This number is a reference to the FCCOB register name and is not the register
address.
FCCOB Number
1
Typical Command Parameter Contents [7:0]
0 FCMD (a code that defines the FTFE command)
1 Flash address [23:16]
2 Flash address [15:8]
3 Flash address [7:0]
4 Data Byte 0
Chapter 17 Flash Memory Module (FTFE)
Kinetis KE1xF Sub-Family Reference Manual, Rev. 4, 06/2019
NXP Semiconductors 379