NXP Semiconductors KE1xF Series, Reference Manual, Page: 1188 / 1483

RTC_CR field descriptions (continued)
Field Description
0 No effect.
1 Resets all RTC registers except for the SWR bit and the RTC_WAR and RTC_RAR registers . The
SWR bit is cleared by POR and by software explicitly clearing it.
45.3.6 RTC Status Register (RTC_SR)
Address: 4003_D000h base + 14h offset = 4003_D014h
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
0
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
0
TCE
0 TAF TOF TIF
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 1
RTC_SR field descriptions
Field Description
31–5
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
4
TCE
Time Counter Enable
When time counter is disabled the TSR register and TPR register are writeable, but do not increment.
When time counter is enabled the TSR register and TPR register are not writeable, but increment.
0 Time counter is disabled.
1 Time counter is enabled.
3
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
2
TAF
Time Alarm Flag
Time alarm flag is set when the TAR[TAR] equals the TSR[TSR] and the TSR[TSR] increments. This bit is
cleared by writing the TAR register.
0 Time alarm has not occurred.
1 Time alarm has occurred.
1
TOF
Time Overflow Flag
Time overflow flag is set when the time counter is enabled and overflows. The TSR and TPR do not
increment and read as zero when this bit is set. This bit is cleared by writing the TSR register when the
time counter is disabled.
0 Time overflow has not occurred.
1 Time overflow has occurred and time counter is read as zero.
Table continues on the next page...
Register definition
Kinetis KE1xF Sub-Family Reference Manual, Rev. 4, 06/2019
1188 NXP Semiconductors