NXP Semiconductors KE1xF Series, Reference Manual, Page: 1184 / 1483

RTC_TPR field descriptions
Field Description
31–16
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
TPR Time Prescaler Register
When the time counter is enabled, the TPR is read only and increments every 32.768 kHz clock cycle. The
time counter will read as zero when SR[TOF] or SR[TIF] are set. When the time counter is disabled, the
TPR can be read or written. The TSR[TSR] increments when bit 14 of the TPR transitions from a logic one
to a logic zero.
45.3.3 RTC Time Alarm Register (RTC_TAR)
Address: 4003_D000h base + 8h offset = 4003_D008h
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
TAR
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
RTC_TAR field descriptions
Field Description
TAR Time Alarm Register
When the time counter is enabled, the SR[TAF] is set whenever the TAR[TAR] equals the TSR[TSR] and
the TSR[TSR] increments. Writing to the TAR clears the SR[TAF].
45.3.4 RTC Time Compensation Register (RTC_TCR)
Address: 4003_D000h base + Ch offset = 4003_D00Ch
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
CIC TCV
CIR TCR
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
RTC_TCR field descriptions
Field Description
31–24
CIC
Compensation Interval Counter
Current value of the compensation interval counter. If the compensation interval counter equals zero then
it is loaded with the contents of the CIR. If the CIC does not equal zero then it is decremented once a
second.
23–16
TCV
Time Compensation Value
Table continues on the next page...
Register definition
Kinetis KE1xF Sub-Family Reference Manual, Rev. 4, 06/2019
1184 NXP Semiconductors