NXP Semiconductors K22F series, Reference Manual, Page: 555 / 1407

MCG_C7 field descriptions
Field Description
7–6
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
5–2
Reserved
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
OSCSEL MCG OSC Clock Select
Selects the MCG FLL external reference clock
NOTE: The OSCSEL field can’t be changed during MCG modes (like PBE), when external clock is
serving as the clock source for MCG.
00 Selects Oscillator (OSCCLK0).
01 Selects 32 kHz RTC Oscillator.
10 Selects Oscillator (OSCCLK1).
11 RESERVED
25.3.12 MCG Control 8 Register (MCG_C8)
Address: 4006_4000h base + Dh offset = 4006_400Dh
Bit 7 6 5 4 3 2 1 0
Read
LOCRE1 LOLRE CME1
0 LOCS1
Write w1c
Reset 1 0 0 0 0 0 0 0
MCG_C8 field descriptions
Field Description
7
LOCRE1
Loss of Clock Reset Enable
Determines if a interrupt or a reset request is made following a loss of RTC external reference clock. The
LOCRE1 only has an affect when CME1 is set.
0 Interrupt request is generated on a loss of RTC external reference clock.
1 Generate a reset request on a loss of RTC external reference clock
6
LOLRE
PLL Loss of Lock Reset Enable
Determines if an interrupt or a reset request is made following a PLL loss of lock.
0 Interrupt request is generated on a PLL loss of lock indication. The PLL loss of lock interrupt enable bit
must also be set to generate the interrupt request.
1 Generate a reset request on a PLL loss of lock indication.
5
CME1
Clock Monitor Enable1
Enables the loss of clock monitoring circuit for the output of the RTC external reference clock. The
LOCRE1 bit will determine whether an interrupt or a reset request is generated following a loss of RTC
Table continues on the next page...
Chapter 25 Multipurpose Clock Generator (MCG)
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 555