NXP Semiconductors K22F series, Reference Manual, Page: 103 / 1407

Table 3-43. ADC Alternate trigger options (continued)
SIM_SOPT7[ADCxTRGSEL] Selected source
0110 PIT trigger 2
0111 PIT trigger 3
1000 FTM0 trigger
1001 FTM1 trigger
1010 FTM2 trigger
1011 FTM3 trigger
1100 RTC alarm
1101 RTC seconds
1110 LPTMR trigger
1111 Reserved
For operation of triggers in different modes, refer to Power Management chapter.
3.7.1.9 ADC conversion clock options
The ADC has multiple input clock sources. Selection is determined by
ADCx_CFG1[ADICLK] bitfield. The following table shows the chip-specific clock
assignments for this bitfield.
NOTE
The ALTCLK option is only usable when OSCERCLK is in the
MHz range. A system with OSCERCLK in the kHz range has
the optional clock source below minimum ADC clock operating
frequency.
Table 3-44. ADC Conversion Clock Options
ADCx_CFG1[ADICLK] ADC defined
selection
Chip clock Note
00 Bus Clock Bus Clock
01 ALTCLK2 IRC48MCLK Note
1
10 ALTCLK OSCERCLK Note
1
11 Asynchronous clock
(ADACK) N/A - sourced from
within ADC block Note
1
1. For ADC operation in Compute only, PSTOP1, Stop and VLPS, ADACK and the alternate clock sources are allowed clock
sources. Note however that ALTCLK2 is force disabled and therefore not available in VLPS.
Chapter 3 Chip Configuration
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 103