NXP Semiconductors JN516x-EK001, User Manual, Page: 15 / 86

JN516x-EK001 Evaluation Kit
User Guide
JN-UG-3093 v1.5 © NXP Laboratories UK 2015 15
The pre-fitted JN5168 modules, the JN5168 USB Dongles and the Remote Control
Unit of this evaluation kit are pre-programmed with the relevant binaries for the
JenNet-IP Smart Home Demonstration (see
Section 1.4 ). However, the JN5168 high-
power modules are not pre-programmed with any application.
The Raspberry Pi board and Linksys router are pre-programmed with NXP firmware.
1.3 Kit Hardware
This section details the hardware devices supplied in the JN516x-EK001 Evaluation
Kit (see
Section 1.2 for full kit contents):

Remote Control Unit (and Programming Dongle) - see Section 1.3.1

Carrier Boards - see Section 1.3.2

Lighting/Sensor Expansion Boards - see Section 1.3.3

Generic Expansion Boards - see Section 1.3.4

LCD Expansion Board - see Section 1.3.5

JN5168 modules - see Section 1.3.4

JN5168 USB Dongles - see Section 1.3.7

Border-Router (Raspberry Pi or Linksys) - see Section 1.3.8
1.3.1 Remote Control Unit (DR1159)
The Remote Control Unit (part number: DR1159) is designed around the JN5168
device and features a 16-button capacitive-touch keypad. The unit is designed as a
wireless network node which can be used to control other nodes of the network.
The unit has the following features:

16 capacitive-touch buttons in a 4x4 keypad with configurable functions

Separate ‘Wake’ button (below keypad) to bring unit out of sleep mode

2 green ultra low-power LEDs

Powered by 2 AAA batteries

Firmware programming through header accessed via the battery compartment
(programmed via supplied dongle - see below)
The front of the unit is shown in Figure 6 , along with the Programming Dongle (part
number: DR1128). Firmware re-programming of the Remote Control Unit is described
in
Appendix B.1 .
The battery compartment is accessed via a slide-cover on the rear of the unit. The
required battery polarities are indicated on the inside of the compartment.
To return the Remote Control Unit to the factory settings at any time, enter the
following key sequence into the unit:
# O - O